Shift Cable - Installation

INSTALLATION






NOTE: Make sure the rubber grommet in the bulkhead is fully seated to prevent water leaking into the passenger compartment.

1. Install the gearshift cable (2) through the bulkhead (1) from the passenger compartment.
2. Seat the rubber grommet onto the bulkhead. Make sure the grommet is fully engage to the bulkhead.





3. Connect the gearshift cable (1) to the bracket.
4. Connect the gearshift cable to the transaxle manual valve lever (2).






NOTE: Make sure the lock tab on the gearshift cable is fully seated after the gearshift cable is installed to the shifter housing.

5. Install the gear shift cable (1) to the shifter. Make sure the lock tab (2) on the gearshift cable is fully seated.
6. Install the knee blocker (2) Kneeblocker - Removal.
7. Install the battery tray Battery Tray - Installation.
8. Install the battery Battery - Installation.