Cooling Fan - Installation

COOLING FAN





1. Install the upper shroud cover (1). Apply pressure downwards until the cover snaps into place past clips (2).
2. Install cooling fan assembly into vehicle.
3. Guide the fan/shroud cover assembly into position between the radiator and upper core support.





4. Position cooling fan assembly onto the mounts (3) located on the radiator.
5. Lock in the fan (1) assembly into place by pressing down firmly on the shroud till the locks (3) engage.
6. Connect electric fan electrical connector (2).





7. Raise and support the vehicle.
8. Install the lower cooling shroud cover by applying upwards pressure till the cover snaps into place onto the cooling fan shroud.
9. If equipped, install the lower engine cover.

10. Lower vehicle.




11. Connect the front section of the A/C liquid line (3) to the rear section of the A/C liquid line (1).
12. Install the nut (2) that secures the two sections of the A/C liquid line together. Tighten the nut to 20 Nm (15 ft. lbs.).





13. Install the bolt (2) that secures the A/C liquid line support bracket (3) to the upper radiator support (1). Tighten the bolt securely.
14. Evacuate the refrigerant system. Adjust the refrigerant oil level. Charge the refrigerant system Refrigerant System Charge.

15. Connect negative battery cable.
16. Install the air intake assembly.
17. Start engine and check fan operation.