Center Mounted Brake Lamp - Installation

INSTALLATION





1. Check to be certain that the two U-nuts in the Center High Mounted Stop Lamp (CHMSL) opening of the liftgate header panel are properly installed and in good condition.
2. Position the CHMSL (3) near the opening in the liftgate header panel.
3. Reconnect the connector (2) of the liftgate wire harness (1) to the connector receptacle on the back of the lamp.
4. Position the CHMSL into the liftgate header opening.
5. Install and tighten the two screws (4) that secure the CHMSL to the liftgate header panel. Tighten the screws to 1.5 Nm (15 in. lbs.).
6. Reconnect the battery negative cable.