Front And Rear Windshield Washer Pump - Removal

FRONT AND REAR





1. Disconnect and isolate the battery negative cable.
2. Siphon the washer fluid from the washer reservoir into a clean container for reuse.
3. Remove the washer reservoir from the cooling module. Windshield Washer Reservoir - Removal.
4. Pull lightly outward on the top of the washer pump/motor housing (2), away from the washer reservoir to disengage the top of the motor from the receptacle in the reservoir.
5. Using hand pressure, firmly grasp and pull the washer pump upward far enough to disengage the pump inlet nipple from the rubber grommet seal/filter screen in the reservoir. Care must be taken not to damage the reservoir.
6. Remove the washer pump/motor unit from the washer reservoir.
7. Remove the rubber grommet seal/filter screen from the washer pump mounting hole in the reservoir and discard.