C15A3

C15A3-00-RIDE HEIGHT SYSTEM MANUALLY SWITCH OFF

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
When the Air Suspension Control Module (ASCM) detects that the system has been diagnostically shut off.





Diagnostic Test

1. VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. With the scan tool, read the DTCs.

Is the DTC active at this time?

Yes

- Go To 2

No

- Go To 3

2. AIR SUSPENSION CONTROL MODULE (ASCM)
1. With the scan tool, check too see if the ASCM has been disabled.

Was the ASCM system disabled?

Yes

- With the scan tool, enable the ACSM system.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Replace the Air Suspension Control Module (ASCM). Air Suspension Control Module - Removal.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

3. INTERMITTENT WIRING AND CONNECTORS
1. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
2. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
3. Look for the data to change or for the DTC to reset during the wiggle test.
4. While monitoring the scan tool data relative to this circuit, move the selector switch to each position several times.
5. Look for the data to change other than as expected or for the DTC to reset.

Were any problems found?

Yes

- Repair as necessary.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time.