C2217

C2217-00 ELECTRIC POWER STEERING MODULE INTERNAL

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Conditions:
If the Electronic Power Steering (EPS) Module detects an internal fault, this DTC will set. Most of internal faults that can set this DTC will result in the EPS assist not operating for the remainder of the current key cycle.





Diagnostic Test
VERIFY THE DTC IS ACTIVE

NOTE: This DTC must be active for the results of this test to be valid.

1. Ignition on, engine not running.
2. With the scan tool, record and erase DTCs.
3. Start the engine.
4. Turn the steering wheel from lock to lock several times.
5. With the scan tool, read DTCs.

Is the DTC active at this time?

Yes

- Replace the Electric Power Steering (EPS) Module. Steering Gear - Removal.
- Perform the EPS VERIFICATION TEST. EPS Verification Test.

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and electrical connectors.
- Perform the EPS VERIFICATION TEST. EPS Verification Test.