Operation CHARM: Car repair manuals for everyone.

U0231






U0231-00-LOST COMMUNICATION WITH LIGHT RAIN SENSING MODULE

For a complete wiring diagram, refer to the Wiring Information.





- When Monitored:
With the ignition on.

- Set Condition:
The Body Control Module (BCM) does not receive information from the Light Rain Sensing Module (LRSM).





Diagnostic Test

1. CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

2. CHECK THE (F982) FUSED IGNITION (RUN/ACC) CIRCUIT FOR AN OPEN




1. Turn the ignition off.
2. Disconnect the Light Rain Sensing Module harness connector.
3. Turn the ignition on.
4. Using a 12-volt test light connected to ground, check the (F982) Fused Ignition (Run/Acc) circuit.

Does the test light illuminate brightly?

Yes

- Go To 3

No

- Repair the open or short to ground in the (F982) Fused Ignition (Run/Acc) circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

3. CHECK THE (Z911) GROUND CIRCUIT FOR AN OPEN




1. Turn the ignition off.
2. Using a 12-volt test light connected to 12-volts, check the (Z911) Ground circuit.

Does the test light illuminate brightly?

Yes

- Go To 4

No

- Repair the open in the (Z911) Ground circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

4. CHECK THE (D402) LIN 2 BUS CIRCUIT FOR AN OPEN




1. Turn the ignition on.
2. Measure the voltage between ground and the (D402) LIN 2 BUS circuit.

Is the voltage above 5.0 volts?

Yes

- Replace the Light Rain Sensing Module. Light Rain Sensor Module (LRSM) - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

No

- Repair the open in the (D402) LIN 2 Bus circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test .