Clearing Trouble Codes

WITH THE SCAN TOOL
Connect the scan tool to the data link connector (16-pin), then erase the diagnostic trouble codes.

WITH THE ABS WARNING LIGHT





1. Depress the brake pedal.
2. Turn the ignition switch on. Do not start the vehicle, only turn ignition to the on position.
3. Within 3 seconds of turning ignition on, you must start releasing and depressing brake pedal for a cycle of 10 repetitions.

CAUTION: The memory cannot be erased under the following conditions.
- When the stop light switch is not turned on and off according to the table in the above image.
- When the generator L terminal voltage increased (HI state).