T1 Switch Check, Default G-Switch Position

- Disconnect G-switch harness connector.

- Remove the G-switch from the vehicle.

- Inspect harness connector and G-switch connector cavity for water or terminal corrosion.

- Place the G-switch on a level surface.

- Measure the resistance between G-switch Pin 1 (Circuit 886) and Pin 3 (Circuit 836).

- Measure the resistance between G-switch Pin 2 (Circuit 887) and Pin 3 (Circuit 836).

- Are both resistances measured less than 5 ohms?

YES -- Go to T2. T2 Switch Check, G-Switch Raised 38.0mm

NO -- All switches should be closed. Replace G-switch. Go to T11.