PC1

- Perform Electrical System Precheck.

- Verify that all of the following connectors are connected and the terminals are secure and free of contaminants or corrosion.

- 2-pin front sensor connectors (2)

- 12-pin HCU connector

- 2-pin pump motor connector

- 16-pin ABS harness connector

- 2-pin ABS power connector

- 2-pin rear axle connector

- Open power distribution box and verify that both the system relay and 60A fuse are fully seated and intact.

- Verify that the system ground eyelet on the driver's side radiator support is firmly attached to the ground stud and is free of corrosion and excessive dirt.

- Are all connections secure and electrical components fully seated and intact?

YES -- Go to PC2. PC2

NO -- Correct condition. Go to PC2. PC2