Front

REMOVAL

1. Raise vehicle on hoist.

2. Remove wheel and tire assembly.

Rotor And Speed Sensor Ring:

3. Remove caliper, rotor and hub assemblies.

Speed Sensor Ring Removal:

4. Using a 3-jaw puller, D80L-1013-A or equivalent, remove speed sensor ring from hub.

CAUTION: Discard old speed sensor ring after removal. Do not reuse.

INSTALLATION

1. Support center of hub so that wheel studs do not rest on work surface.

CAUTION: When performing the following step, make sure indicator ring is pressed on straight.

Front Speed Sensor Ring Installation:

2. Position new speed sensor ring on hub. Using a cylinder with 98mm (3.9 inch) ID and 106mm (4.2 inch) OD, press the ring on to the hub. The ring must be fully seated against the shoulder in the hub.

3. Install hub, rotor and caliper assemblies.

4. Install wheel and tire assembly. Tighten wheel lugnuts to 115-142 Nm (85-105 ft lb).