System Pre Check

Connector Diagram:

DESCRIPTION
Code 10 is generated by the anti-lock electronic control module's detection of low speed sensor resistance. The code may also be generated by a short circuit in the Circuits 519 (LG/BK) or 523 (R/PK), or a failed internal anti-lock electronic control module circuit.


POSSIBLE CONTRIBUTING BASE BRAKE COMPONENT/VEHICLE WIRING CONCERNS

- Short between anti-lock electronic control module harness connector Pin 3 and Pin 10
- Short between RABS speed sensor connector Pins A and B
- Bulkhead connector (between engine compartment and instrument panel) speed sensor terminals shorted together
- Intermittent short circuit in Circuits 519 (LG/BK) or 523 (R/PK)

NOTE: Use Rotunda(r) 73 Digital Multimeter 105-00051 or equivalent for electrical tests.