Rear Bench Seat

REMOVAL
1. Fold rear seat cushion assembly forward.







2. Remove the retaining nut from end of link arm and side link arm off stud on seat cushion frame.
3. Rotate seat back assembly back to upright position.







4. Remove the retaining nuts from front floor attachment.
5. Remove the seat cushion assembly from vehicle.







6. Remove the restraint retaining bolt and retaining nut.







7. Slide seat back assembly off center pivot bracket and remove from vehicle.

INSTALLATION
1. Install the seat back (with link arm) onto the pin on the center pivot bracket and position the seat on to the floorpan.







2. Install the nut and bolt retaining the seat back and seat belt to the floorpan.







3. While keeping the seat cushion rotated in a forward position, place the cushion onto the studs in the floorpan, install two nuts that attach the cushion to the floorpan.







4. Rotate the seat back downward and slide the link arm over the stud on the outboard face of the cushion; install the nut that attaches the link arm to the cushion.