Front

REMOVAL
1. Connect New Generation STAR (NGS) Tester to the data link connector (DLC).

NOTE: Place the four wheel drive in NORMAL.

2. Select the RIDE CONTROL OUTPUT screen and turn on the following solenoids to vent the entire system of air and to lower the vehicle to its lowest attainable height:
- FRONT_FIL (front fill solenoid).
- REAR_FIL (rear fill solenoid).
- GATE (gate solenoid[s]).
- VENT (vent solenoid).

3. Raise and support the vehicle.

WARNING: THE ELECTRICAL POWER TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO HOISTING, JACKING OR TOWING OF AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE AIR SUSPENSION SWITCH LOCATED IN THE REAR JACK STORAGE AREA. FAILURE TO DO SO MAY RESULT IN UNEXPECTED INFLATION OR DEFLATION OF THE AIR SPRINGS WHICH MAY RESULT IN SHIFTING OF THE VEHICLE DURING THESE OPERATIONS.





4. Pry the solenoid from the frame.





5. Push in the red ring and remove the air lines.





6. Disconnect the electrical connector.

INSTALLATION
1. To install, reverse the removal procedure.