Alternator Brush: Service and Repair

GENERATOR BRUSH AND TEMRMINAL HOLDER

REMOVAL
1. Remove the Generator (GEN).







2. Remove the generator brush and terminal holder and the Voltage Regulator (VR).
1. Remove the screws.
2. Remove the generator brush and terminal holder and the voltage regulator.







3. Separate the generator brush and terminal holder from the voltage regulator.
1. Remove the screw cap.
2. Remove the screws.
3. Separate the generator brush and terminal holder from the voltage regulator.

INSTALLATION







1. Install the brush and terminal holder on the voltage regulator.
1. Position the brush and terminal holder on the voltage regulator.
2. Install the screws.
3. Install the screw cap.

CAUTION: Make sure screw cap is installed over test terminal A to prevent accidental shorting of the battery positive (B+) connection.







2. Install the generator brush and terminal holder and the voltage regulator.
1. Depress the brushes and insert a wire to hold them.
2. Position the generator brush and terminal holder and the voltage regulator.
3. Install the screws.
4. Remove the wire.
3. Install the generator.