Ignition Coil: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Disconnect the ignition coil electrical connections.
1 Squeeze the locking tab and twist while pulling upward to disconnect the eight spark plug wires.
2 Disconnect the radio ignition interference capacitor connector.
3 Disconnect the two ignition coil electrical connectors.

CAUTION: The spark plug wires must be connected to the proper ignition coil terminal. Mark spark plug wire locations before removing them.







3. Remove the ignition coils.
1 Remove the bolts.
2 Remove the ignition coils.







INSTALLATION
1. Follow the removal procedure in reverse order.

NOTE: Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171-A to the inside of the spark plug and coil plug wire boot.