Seal - Front Output

Special Tools:

Removal
1. Raise and support the vehicle.

2. CAUTION: Index mark the driveshaft to the flange to maintain proper driveline balance.

Disconnect the front driveshaft at the transfer case and position it aside.

3. While using the Companion Flange Holding Tool to prevent the flange from turning, remove and discard the nut.

4. Using the Flange Remover, remove the flange.

5. Using the Converter Oil Seal Remover, remove the front output seal.
6. Inspect the flange seal surface for wear and replace if necessary.

Installation

1. Follow the removal procedure in reverse order.
^ Using the Output Shaft Seal Installer and Handle, install a new front output seal.