Rear Center Safety Belt Retractor

Safety Belt Bolt Bit:

SPECIAL TOOL(S)

REMOVAL

WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT ASSEMBLIES (SLIDE BAR), SHOULDER BELT HEIGHT ADJUSTERS (IF SO EQUIPPED) CHILD SAFETY SEAT TETHER ATTACHMENTS AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLES SHOW NO DAMAGE AND OPERATE PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER DAMAGE OR IMPROPER OPERATION IS NOTED.

1. Fold the rear seat down to load floor position.







2. Remove the rear safety belt buckle and retractor assembly.
1 Using the special tool, remove the bolt.
2 Remove the rear safety belt buckle and retractor assembly.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

2. Check the restraint system for correct operation.