Rear Safety Belt Retractor

REAR SAFETY BELT RETRACTOR - SPORT

Safety Belt Bolt Bit:

SPECIAL TOOL(S)


REMOVAL

WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height adjusters (if so equipped), child safety seat tether attachments, and attaching hardware should be inspected after any collision. All belt assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.


NOTE: The driver side is shown, the passenger side is similar.

1. Remove the rear quarter trim panel.







2. Using the special tool, remove the rear shoulder safety belt guide bolt and guide.







3. Using the special tool, remove the rear safety belt anchor bolt and anchor.







4. Remove the bolt and the safety belt retractor.

INSTALLATION

1. NOTE:
- Make sure the safety belt webbing is not twisted prior to installation.
- Make sure to tighten all nuts and bolts to specification.

To install, reverse the removal procedure.

2. Check the active restraint system for correct operation.