Rear Window Glass - Power

REAR WINDOW GLASS - POWER

REMOVAL
1. Remove the C-pillar trim panel.







2. Remove the spare tire and jack assembly.







3. Remove the roof trim panel.







4. If equipped, remove the sub-woofer assembly.
1 Disconnect the electronic connector.
2 Remove the bolts.







5. NOTE: Do not remove the power rear window motor water shield.

Remove the carpet pin-type retainers and pull the carpet back.







6. Position the rear window glass regulator access panel aside.
1 Remove the screws.
2 Remove the nut.
3 Position the rear window glass regulator access panel aside.

7. Position the rear window glass to the 3/4 down position.







8. Remove the rear window weatherstrip moulding.
9. Remove the rear window glass bolts.


10. NOTE: When securing the rear window glass note that the rear window glass and module will be removed with the rear window glass in the secured position.

Secure the rear window glass in the full up position.







11. Remove the 12 rear window glass module nuts.
12. Push the rear window glass module out at the top.







13. NOTE: In order for the rear window glass to function correctly the locating clip must engage the pinch weld at the rear of the cab during installation.

Lift the rear window glass module from the rear of the cab to disengage the locating clip.

14. Remove the excess foam butyl from the window opening.







15. If necessary, remove the center rear window glass from the module.

INSTALLATION







1. To install, reverse the removal procedure.
- Apply 6 mm (0.23 in) Foam Butyl or equivalent meeting Ford specification ESB-M3G143-B to the rear window glass module.
- Start at the bottom and work around the module.

2. Reinitialize the rear window glass motor.