Valve Cover - RH
Valve Cover - RHRemoval and Installation
1. Drain the cooling system.
2. Remove the air cleaner outlet pipe.
^ Disconnect the tube.
^ Detach the Mass Air Flow (MAF) sensor wiring pushpin.
^ Loosen the clamps and remove the pipe.
3. Release hose clamps and remove hose.
4. Remove hose.
5. Disconnect the vacuum hose.
6. Loosen hose clamps and disconnect hoses.
7. Release hose clamps and disconnect hoses.
8. Release hose clamp and disconnect hose.
9. Release hose clamp and disconnect hose. Position hose aside.
10. Remove the bolts.
11. Detach the wiring harness retainer.
^ Remove the heater tube and bracket assembly.
12. Disconnect MAP sensor connector and wiring pushpin. Position wiring aside.
13. CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
NOTE: Spark plug wires must be connected to the correct ignition coil terminal. Mark spark plug wire locations before removing them.
Position the spark plug wires aside.
1) Disconnect the spark plug wires.
2) Disconnect the spark plug wire retainer and position the wires aside.
14. Disconnect fuel injector connectors. Position wiring aside.
15. Remove the bolts and the valve cover.
16. To install, reverse the removal procedure.