Autolock and Horn Chirp Programming

AUTOLOCK AND HORN CHIRP PROGRAMMING

Using the Keyless Entry Keypad

NOTE: A manual enable/disable mode allows the autolock feature to be turned off and on.

1. Enter the five-digit permanent entry code into the keyless entry keypad.
2. Within five seconds of entering the code, press and hold the 7/8 button on the keypad.
3. Within five seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keypad and release it.

4. NOTE: If the autolock feature is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly then sounds a second time for a longer sound of the horn once the above sequence is completed.

Within five seconds of Step 3, release the 7/8 button on the keypad.

Using the Ignition Lock Cylinder
1. Close all the doors.
2. Confirm that the ignition switch is in the OFF position.
3. Turn the ignition switch from OFF to ON.

4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.

Press the door lock control switch UNLOCK button three times.

5. Turn the ignition switch from ON to OFF.
6. Press the door lock control switch UNLOCK button three times.
7. Turn the ignition switch from OFF to ON.
8. Verify that the horn chirps. This indicates the system is in the enable/disable mode is ready to accept program changes.
9. Press the door lock control switch UNLOCK button one time to toggle the autolock/relock feature OFF.
10. Press the door lock control switch LOCK button once to enter the command.
11. Verify that the horn chirps one time. There should only be one chirp indicating that autolock/relock feature has been disabled. If one chirp is heard, followed by a longer sound of the horn, the autolock/relock feature has just been enabled. Return to Step 9.
12. Turn the ignition switch to the OFF position to exit the enable/disable mode.
13. Exit the vehicle and verify that the horn chirps once to indicate that a feature has been changed and that autolock/relock has been disabled.