Battery Cables - Auxiliary

BATTERY CABLES - AUXILIARY

Removal

1. CAUTION: Failure to accurately follow the battery disconnect procedures outlined will result in vehicle or component damage.

Disable the vehicle electrical supply.

2. Disconnect the primary battery positive cable, and remove the hold-down wedge and the primary battery. Remove the auxiliary battery.
3. Remove the 4 bolts retaining the battery tray and remove the battery tray.







4. Remove 3 rear harness locators, 2 to the rear of the vacuum reservoir and 1 to the front of the vacuum reservoir, along the RH frame rail.
5. Pull the harness through the vacuum reservoir and the frame.







6. Remove 3 front harness locators, along the RH frame rail, and pull the harness through the front body mounting point.







7. Remove the engine compartment harness locator.







8. Remove the nut and disengage the harness eyelet.
9. Pull the harness out from the engine compartment.

Installation












1. CAUTION: Failure to accurately follow the battery reconnect procedures outlined will result in vehicle or component damage.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

To install, reverse the removal procedure.