Exhaust Manifold RH

Exhaust Manifold-RH




Material

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the engine cover.
4. Prior to removing the exhaust manifold, inspect the exhaust manifold for warpage with a feeler gauge between the manifold and the cylinder head. Record the measurement and compare with the specifications.





5. Remove the RH bolts for the turbocharger adapter pipe.





6. NOTE: Top bolts shown, bottom bolts similar.

Remove the bolts and the RH exhaust manifold.

Installation





1. NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.

NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the RH exhaust manifold and bolts. Tighten the bolts in the sequence shown.





2. NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the RH bolts for the turbocharger adapter pipe.
3. Install the engine cover.
4. Connect the battery ground cable.