Rear Seat Backrest - Second Row, 20 Percent
REAR SEAT BACKREST - SECOND ROW, 20 PERCENTRemoval and Installation
1. Remove the seat from the vehicle.
2. Remove the 3 screws and the latch trim covers.
3. Remove the 3 screws and the pivot latch trim covers.
4. Remove the release handle cable.
1 Pinch to release the retainer clip.
2 Remove the cable end hook from the retaining hole.
3 Position the cable to the side.
5. Release the seat backrest J-clip. Remove all the staples and lift the material to expose the backrest nut and bolts.
6. Remove the safety belt buckle and retractor belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).
7. Remove the 2 upper latch bolts
- To install, tighten to 40 Nm (30 lb-ft).
8. Remove the backrest pivot nut.
- To install, tighten to 40 Nm (30 lb-ft).
9. Remove the backrest.
10. To install, reverse the removal procedure.