Radiator Cooling Fan Motor: Service and Repair
Cooling Fan Motor and ShroudCooling Fan Motor And Shroud:
Removal and Installation
All vehicles
1. With vehicle in NEUTRAL, position it on a hoist.
2. Remove the front impact severity sensor.
3. Remove the 2 pushpin retainers from the front bumper bracket.
4. Remove the 2 front grille bolts.
^ To install, tighten to 10 Nm (89 inch lbs.).
3.0L vehicles only
5. Drain the cooling system.
6. Disconnect the transmission cooler hose.
All vehicles
7. Remove the 4 bolts and the 2 radiator brackets.
^ To install, tighten to 10 Nm (89 inch lbs.).
8. Remove the center support lower bolt.
^ To install, tighten to 10 Nm (89 inch lbs.).
9. Remove the nut and the center support.
^ To install, tighten to 10 Nm (89 inch lbs.).
10. Disconnect the cooling fan electrical connectors
11. Remove the 2 cooling fan bolts and the cooling fan motor and shroud.
^ To install, tighten to 10 Nm (89 inch lbs.).
12. To install, reverse the removal procedure.
3.0L vehicles only
13. Fill and bleed the cooling system.