Transmission Mount: Service and Repair

Transmission Support Insulator - 4x4

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Support the transmission with a transmission jack.





3. Remove the 2 nuts from the rear transmission support.

4. NOTE: Crossmember and exhaust system shown removed.

NOTE: LH shown, RH similar.





Remove the 2 bolts and remove the rear transmission support.

Installation





1. Install the rear transmission support and bolts.
^ Tighten to 90 Nm (66 ft. lbs.).





2. Lower the rear mount onto the crossmember and tighten the rear transmission support nuts.
^ Tighten to 90 Nm (66 ft. lbs.).