Generator - Single Generator

GENERATOR - SINGLE GENERATOR







Removal and Installation

NOTE: Single generator is shown; primary generator on the dual generator vehicle is similar.

1. Disconnect the batteries.
2. Remove the cooling fan.
3. Remove the nut and position the generator B+ terminal aside.
- To install, tighten to 8 Nm (71 lb-in).

4. Disconnect the generator electrical connector.
5. Rotate the accessory drive belt tensioner clockwise and remove the drive belt from the generator pulley.
6. Remove the 3 bolts and the generator.
- To install, tighten to 47 Nm (35 lb-ft).

7. To install, reverse the removal procedure.