B-Pillar Trim Panel - Regular Cab

B-PILLAR TRIM PANEL - REGULAR CAB

Special Tool(s):

Special Tool(s)

Removal and Installation

Both B-pillar trim panels







1. Remove the door scuff plate trim panel.
1 Remove the screws.
2 Remove the scuff plate.

RH B-pillar trim panel
2. Remove the handle carrier cover.







3. Remove the jack handle carrier.
1 Remove the screws.
2 Remove the jack handle carrier.

LH B-pillar trim panel
4. Remove the package tray mat.







5. Remove the package tray.
1 Remove the screws.
2 Remove the package tray.

Both B-pillar trim panels







6. NOTE:
- If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.
- Safety belt guide cover removed for clarity.

From behind the front safety belt guide cover, release the tab and open the cover.







7. Remove the nut and safety belt guide.
- To install, tighten to 40 Nm (30 lb-ft).







8. Disconnect the safety belt anchor.
1 Use the Safety Belt Bolt Bit to remove the bolt.
- To install, tighten to 40 Nm (30 lb-ft).

2 Disconnect the safety belt anchor.







9. Reposition the B-pillar trim panel.
1 Remove the pin-type retainers.
2 Reposition the B-pillar trim panel.







10. Disconnect the radio speaker electrical connector.







11. Lower the rear of the A-pillar trim panel to remove the B-pillar trim panel.
12. Remove the B-pillar trim panel.
13. To install, reverse the removal procedure.