Selector Lever Knob

Selector Lever Knob

Vehicles Equipped With a 6R75 Transmission:

Vehicles Equipped With a 6HP26 Transmission:

Removal

1. NOTE: 6R75 transmission selector lever shown, 6HP26 similar.

Remove the PRNDL trim, console tray and cup holder insert.





2. Remove the screw and the console upper trim.





3. Remove and discard the RH selector lever knob cover.
1 Start at the bottom rear only.
2 Work towards the top.





4. Remove and discard the LH selector lever knob cover.
1 Start at the bottom rear only.
2 Work towards the top.





5. Remove and discard the RH selector lever knob screw.





6. Remove and discard the LH selector lever knob screw.





7. Disconnect the transmission control (TC) switch electrical connector and remove the selector lever knob.





Installation
1. Connect the transmission control (TC) switch electrical connector and install the selector lever knob.





2. Install a new LH selector lever knob screw.





3. Install a new RH selector lever knob screw.





4. NOTE: Wood trimmed vehicles have a rubber damper not found on other trim levels.

Install a new LH selector lever knob cover.





5. NOTE: Wood trimmed vehicles have a rubber damper not found on other trim levels.

Install a new RH selector lever knob cover.





6. Install the console upper trim and the screw.





7. Install the PRNDL trim, console tray and cup holder insert.