Fan Shroud: Service and Repair
Cooling Fan ShroudSpecial Tools:
Removal and Installation
Vehicles equipped with a 4.6L (3V) engine
1. Remove the air cleaner outlet pipe.
All vehicles
2. Remove the coolant expansion tank.
3. Remove the bolt and position the power steering fluid reservoir aside.
^ To install, tighten to 10 Nm (89 inch lbs.).
4. Remove the bolts, then unclip the upper fan shroud from the lower fan shroud and remove the upper fan shroud.
^ To install, tighten to 7 Nm (62 inch lbs.).
5. Disconnect the fan clutch electrical connector.
6. Remove the fan clutch wiring harness bracket bolt.
^ To install, tighten to 7 Nm (62 inch lbs.).
7. Using the special tools, remove the cooling fan.
^ To install, tighten to 55 Nm (41 ft. lbs.).
8. Remove the bolts and the lower fan shroud.
^ To install, tighten to 7 Nm (62 inch lbs.).
9. To install, reverse the removal procedure.