Selector Lever

Selector Lever

Selector Lever:

Removal
1. Remove the front floor console. For additional information, refer to Console.
2. Disconnect the selector lever cable from the selector lever.





3. Disconnect the selector lever cable from the selector lever housing.





4. Disconnect the electrical connector.





5. Disconnect the wiring harness from the selector lever housing.





6. Remove the 4 nuts and remove the selector lever housing from the vehicle.





Installation

NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the cable end is correctly installed.

1. Install the selector lever housing.
^ Tighten to 9 Nm (80 inch lbs.)





2. Connect the wiring harness to the selector lever housing.





3. Connect the electrical connector.





4. Install the selector lever cable onto the selector lever housing.





5. Connect the selector lever cable onto the selector lever.





6. Install the front floor console. For additional information, refer to Console.