Disc Removal and Installation, Rear

Brake Disc





Removal and Installation
1. Release the parking brake.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the parking brake cable from the brake caliper.
1 Pull back the parking brake lever.
2 Disconnect the cable from the parking brake lever.
3 Remove the cable conduit retaining clip.
4 Remove the cable from the brake caliper.





4. CAUTION: Do not allow the brake caliper to hang from the hose or damage to the hose can occur.

Remove the 2 brake caliper anchor plate bolts. Position the anchor plate and brake caliper aside as an assembly.
^ Support the assembly with mechanic's wire.
^ To install, tighten to 55 Nm (41 ft. lbs.).
5. Remove the brake disc.
^ If equipped, remove the retaining clip.
6. To install, reverse the removal procedure.