Sunroof / Moonroof Windguard: Service and Repair
AIR DEFLECTORExploded View
Exterior Trim, Seals, Fixed Glass and End Caps:
Air Deflector Assembly:
Sliding Glass, Blinds and Primary Seal:
Idler Track and Mechanism:
Front and Rear Sunshade Assembly:
Rear Trim Ring Assembly:
Roof Opening Panel Motor(s) and Electrical:
Motor Block and Drive Tube Assembly:
Guide Tracks and Mechanisms:
Front Guide Track Mechanism:
Removal and Installation
NOTE: There may be a special service replacement fastener available if a screw hole becomes stripped during installation.
1. Position the roof opening panel glass to the full OPEN position.
2. Remove the 2 air deflector-to-track screws and air deflector arm capture plate.
- NOTE: If the nut plate(s) becomes stripped during installation, a new nut plate can be installed.
To install, tighten to 2 Nm (18 lb-in).
3. Remove the 6 air deflector catcher bracket screws.
- To install, tighten to 2 Nm (18 lb-in).
4. Remove the air deflector assembly.
5. To install, reverse the removal procedure.