Test G: The Roof Opening Panel Shade Does Not Open Or Close - Both Shades

PINPOINT TEST G: THE ROOF OPENING PANEL SHADE DOES NOT OPEN OR CLOSE - BOTH SHADES

The roof opening panel shade motor/module must be initialized whenever the roof opening panel shade motor/module has been removed from the roof opening panel system, the roof opening panel module assembly has been removed from the vehicle, a new roof opening panel shade motor/module has been installed or a new roof opening panel module assembly has been installed. Refer to Roof Opening Panel Motor Initialization. Programming and Relearning

Normal Operation
The roof opening panel shade uses an integrated motor and module to operate the roof opening panel shades.

The roof opening panel shade motor/module receives voltage through circuit SBB18 (YE/RD). When the key is in the ACC or RUN position, the roof opening panel motor/module sends a signal to the roof opening panel shade motor/module. Ground is supplied to the roof opening panel shade motor/module through circuit GD133 (BK). The roof opening panel switch receives ground from the roof opening panel motor/module assembly through circuit GD133 (BK). When the roof opening panel shade OPEN switch is pressed, the roof opening panel switch grounds circuit CPR37 (YE/GY) and the roof opening panel shade motor/module opens the roof opening panel shade. When the roof opening panel shade CLOSE switch is pressed, the roof opening panel switch grounds circuit CPR32 (YE/GN) and the roof opening panel shade motor/module closes the roof opening panel shade.

This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Open in voltage or ground circuit of the overhead jumper harness
- Roof opening panel switch
- Roof opening panel shade panel motor/module
- Roof opening panel shade motor not initialized

G1-G3:

G4-G6: