40 Percent
SEAT BACKREST COVER - REAR, 40 PERCENTExploded View
Rear Seat Cushion, 40 Percent:
Rear Seat Backrest, 40 Percent (Part 1):
Rear Seat Backrest, 40 Percent (Part 2):
Rear Seat Cushion, 60 Percent:
Rear Seat Backrest, 60 Percent (Part 1):
Rear Seat Backrest, 60 Percent (Part 2):
Removal and Installation
NOTE: A new heater mat will come assembled on a new foam pad.
1. Remove the 40 percent seat.
2. Remove the 40 percent cushion.
3. Remove the head restraint.
1 Push in the hole, lift up on the head restraint and release one side of the head restraint.
2 Push the release button and remove the head restraint.
3 Remove the safety belt comfort guide.
4. NOTE: Always install a new slave head restraint guide.
Pull out and remove the master and slave head restraint guides.
5. Release the tabs and remove the child safety seat tether anchor bezel.
6. Release the backrest trim cover lower J-clip.
- Pull the heated seat electrical connector through the backrest trim cover opening (if equipped).
7. At the rear inboard side of the backrest, access the zipper tucked up behind the back panel and unzip the zipper.
8. Remove the pin-type retainer holding the backrest trim cover around the lower anchors and tethers for children (LATCH) and attaching to the lower rear of the backrest frame.
9. Remove the pin-type retainer from inside the safety belt comfort guide pocket.
10. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the backrest foam pad.
Release the hook-and-loop strips and invert the backrest trim cover in an inside out fashion to the wire in the backrest trim cover attached to the clips in the backrest foam pad.
11. Separate the backrest trim cover wire from the clips in the backrest foam pad and remove the backrest trim cover.
12. To install, reverse the removal procedure.