Seat Cushion Cover - Front

SEAT CUSHION COVER - FRONT

Exploded View

Front Seat Backrest, Manual and Power Recline, Without Fold Flat (Part 1):

Front Seat Backrest, Manual and Power Recline, Without Fold Flat (Part 2):

Front Seat Backrest, Manual Recline With Fold Flat (Part 1):

Front Seat Backrest, Manual Recline With Fold Flat (Part 2):

Seat Cushion With Power Seat Track (Part 1):

Seat Cushion With Power Seat Track (Part 2):

Driver Seat Cushion With Manual Seat Track (Part 1):

Driver Seat Cushion With Manual Seat Track (Part 2):

Passenger Seat Cushion With Manual Seat Track:

Passenger Power Seat Track (Part 1):

Passenger Power Seat Track (Part 2):

Special Tool(s)

Special Tool(s):

Removal and Installation

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Remove the front seat.
2. Remove the front seat cushion.
3. Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.

4. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the cushion foam pad.

NOTE: A new heater mat will come assembled on a new foam pad.

Remove the cushion trim cover in the following sequence.
1 Separate the hook-and-loop strips.
2 Separate the cushion trim cover wire retainer from the clips in the cushion foam pad.
- For vehicles with climate controlled seats, on assembly make sure the climate controlled seat manifold is in place before snapping the cushion trim cover wire retainer back into the cushion foam pad.

3 Remove the cushion trim cover.

5. To install, reverse the removal procedure.
6. Install the front seat cushion.
- For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing - Front Passenger Cushion.

7. Install the front seat. If a passenger seat has been serviced, do not prove out the SRS at this time.

Passenger seat
8. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test.