Driveshaft Indexing
Driveshaft IndexingNOTE: If indexing the driveshaft does not eliminate the vibration, balance the driveshaft. For additional information, refer to Driveshaft Runout and Balancing. Driveshaft Runout and Balancing
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. CAUTION: Do not reuse the constant velocity (CV) joint bolts. Install new bolts or damage to the vehicle may occur.
Remove and discard the 6 front driveshaft-to-transfer case bolts and 3 double washers.
3. NOTE: Index-mark the shaft for reference.
Rotate the flange 90 degrees clockwise.
4. Connect the front driveshaft and install the 6 new bolts and 3 new washers.
^ Tighten to 40 Nm (30 lb-ft).
5. CAUTION: Do not reuse the bolts for the pinion yoke. Install new bolts or damage to the vehicle may occur.
Disconnect the rear driveshaft U-joint flange.
^ Discard the 4 bolts.
6. Rotate the rear pinion 90 degrees clockwise.
7. Connect the rear driveshaft and install 4 new bolts.
^ Tighten to 70 Nm (52 lb-ft).
8. Test drive the vehicle.
9. Repeat the procedure if necessary.