Differential Seals - RH

Differential Seals - RH

Material:

Material:

Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the transaxle drain plug and drain the transmission fluid.





3. Remove the RH halfshaft and intermediate shaft.
4. If equipped, remove the power transfer unit (PTU).
5. If the vehicle is equipped with a PTU, use the special tools to remove the RH differential seal.





6. If the vehicle is not equipped with a PTU, use the special tools to remove the RH differential seal.





Installation
1. If the vehicle is equipped with a PTU, use the special tools to install the RH differential seal.





2. If the vehicle is not equipped with a PTU, use the special tools to install the RH differential seal.





3. If equipped, install the PTU.
4. Install the RH halfshaft.
5. Using a small amount of thread sealant on the threads, install the transaxle drain plug.
^ Tighten to 25 Nm (18 lb-ft).





6. Fill the transaxle with clean automatic transmission fluid.
7. Start the engine and run through all the gears and check the fluid level.