Removal and Replacement
Engine Support InsulatorsSpecial Tool(s):
Removal and Installation
1. Remove the lower intake manifold.
2. Remove the engine support insulator bracket bolt.
^ To install, tighten to 90 Nm (66 lb-ft).
3. Install the special tools.
1. Position the 2 universal adapter brackets on top of the cylinder block.
2. Install 2 M8 x 1.25 x 36 mm (1.41 in) bolts and tighten to 10 Nm (89 lb-in).
3. Position the universal lifting bracket onto the 2 universal adapter brackets.
4. Fasten the universal lifting bracket to the 2 universal adapter brackets with a suitable nut and bolt.
4. Using the special tools, lift the engine 12 mm (0.47 in).
5. Remove the nut and ground wire eyelet from the engine support insulator bracket stud.
^ To install, tighten to 25 Nm (18 lb-ft).
6. Remove the 3 nuts and the engine support insulator bracket.
^ To install, tighten to 55 Nm (41 lb-ft).
7. Remove the 3 bolts and the engine support insulator.
^ To install, tighten to 48 Nm (35 lb-ft).
8. To install, reverse the removal procedure.