Brake Shift Interlock Actuator - Floor Shift

Brake Shift Interlock Actuator - Floor Shift

Brake Shift Interlock Actuator (BSIA) - Floor Shift:

Removal
1. Remove the floor console left side kick panel.





2. Lift the console storage lid cover and remove the console finish panel.





3. Disconnect the selector lever cable from the arm of the selector lever.





4. Disconnect the selector lever cable from the selector lever cable bracket on the selector lever.





5. Remove the selector lever bolts.





6. Disconnect the selector lever electrical connector and remove the selector lever from the vehicle.





7. Disconnect the electrical connector.
1 Disconnect the overdrive cancel button electrical connector.
2 Cut the tie strap holding the wire harness to the base of the selector lever.





8. Remove the brake shift interlock actuator (BSIA).
1 Remove the bulb from the housing.
2 Cut the tie strap from the wire harness.
3 Remove the 2 screws and remove the BSIA.





Installation
1. Install the BSIA.
1 Install the BSIA and install the 2 screws.
2 Install the bulb into the housing.
3 Install a new tie strap on the wire harness.





2. Connect the electrical connector.
1 Connect the overdrive cancel button electrical connector.
2 Install a new tie strap to the wire harness.





3. Position the selector lever assembly in the console and install the bolts.
^ Tighten to 12 Nm (9 lb-ft).





4. Connect the selector lever electrical connector.





5. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.

Install the selector lever cable in the selector lever cable bracket.





6. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.

Connect the selector lever cable to the selector lever arm.





7. Install the console finish panel.
8. Install the left console kick panel.