Test G: TPMS Indicator FLASHES for 70 Seconds and Then Remains ON Solid When The Ignition Key is Turned to The ON Position and

Pinpoint Test G: TPMS Indicator FLASHES for 70 Seconds and Then Remains ON Solid When the Ignition Key is Turned to the ON Position and DTC B287A or B2872 is Present

Normal Operation
If there is a fault in the tire pressure monitoring system (TPMS), such as a damaged or missing sensor(s), damaged module or a communication issue within the vehicle, DTCs are set in the smart junction box (SJB), the TPMS warning indicator will flash for 70 seconds and then remain ON solid when the ignition switch is turned to the ON position and the message center (if equipped) will display TIRE PRESSURE SENSOR FAULT. If the SJB does not get a response from all 4 TPMS sensors, DTC B287A may be set and the message center (if equipped) will display TIRE PRESSURE MONITOR FAULT.

B2872 Tire Pressure Sensor Fault - When 1, 2 or 3 of the tire pressure sensors are faulted or not responding, the SJB will set DTC 2872.

B287A Tire Pressure Monitor Fault - When all 4 of the tire pressure sensors are faulted, not responding or not heard by the SJB, the SJB will set DTC B287A.

This pinpoint test is intended to diagnose the following:
^ TPMS sensor(s) missing
^ TPMS sensor(s) not trained to the vehicle
^ TPMS sensor(s) swapped due to wheel swap
^ TPMS sensor(s) damaged
^ Vehicle communication issue

G1:

G2-G3:

G4: