Steering Column Multifunction Switch

Steering Column Multifunction Switch

Steering Column Multifunction Switch:

Removal and Installation
1. Remove the ignition switch lock cylinder.
1 Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2 Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
2. If equipped, remove the tilt release lever/ handle.
3. Remove the 3 steering column shroud screws and the upper and lower steering column shrouds.
4. Disconnect the multi-function switch electrical connectors.
5. Remove the 2 multi-function switch screws and the multi-function switch.
^ To install, tighten to 3 Nm (27 lb-inch).

6. To install, reverse the removal procedure.