Input Shaft Bearing

Input Shaft Bearing








Disassembly
1. Remove and discard the front bearing oil scoop ring.





2. Position the input shaft on a press. Using the special tool, remove and discard the input shaft bearing. Hold the input shaft from underneath so it does not fall.
^ Always install new bearings and cups as a set. Do not install one without the other.





3. Inspect the input shaft for damage or wear.
^ Inspect the surface of the input shaft in the area of the bearing race to make sure it is smooth and free of burrs.
^ Inspect the splines for nicks. Install a new input shaft as necessary.

Assembly
1. Using the special tools and a press, install a new input bearing shaft.





2. Install the front bearing oil scoop ring.
^ A click should be felt as the scoop ring notches align with the input shaft oil holes.