6F35 Automatic Transmission - Transmission Fluid Cooler Tubes

Transmission Fluid Cooler Tubes

Removal

NOTICE: Automatic transmission fluids are not interchangeable transmission fluids. The use of any fluid other than what is recommended for this transaxle will cause transaxle damage.

1. Remove the front bumper cover.

2. Remove the left side splash shield.

3. Release the transmission fluid cooler tube retaining clip and remove the transmission fluid cooler tubes from the clip.

4. Compress the constant tension clamps and remove the transmission fluid cooler tubes from the transmission fluid cooler.

5. Remove the secondary latches from the transmission fluid cooler tubes at the transmission.

6. Using the Transmission Cooler Line Disconnect Tool, disconnect the transmission fluid cooler tubes from the transaxle and remove the transmission fluid cooler tubes.

Installation

1. If installing new transmission fluid cooler tubes, remove the secondary latches and the retainer from the old transmission fluid cooler tubes and install them on the new transmission fluid cooler tubes.

2. Position the transmission fluid cooler tubes in place. Install the transmission fluid cooler tubes in the transaxle by inserting the tube into the fitting until a click is heard/felt. Pull back to confirm connection is secure and install the secondary latches.

3. Compress the constant tension clamps and install the transmission fluid cooler tubes on the transmission fluid cooler.

4. Install the transmission fluid cooler tubes in the retaining clip and close the retaining clip.

5. Install the left side splash shield.

6. Install the front bumper cover.

7. Check the transmission fluid level and add transmission fluid as necessary.