Transaxle Rear Support Insulator

Transaxle Rear Support Insulator









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the transaxle rear support insulator bolt.
- To install, tighten to 80 Nm (59 lb-ft).

3. Remove the 2 transaxle rear support insulator nuts.
- To install, tighten to 80 Nm (59 lb-ft).

4. Remove the transaxle rear support insulator through-bolt and washer.
- To install, tighten to 115 Nm (85 lb-ft).

5. Remove the transaxle rear support insulator.

6. If necessary, remove the 3 bolts and the transaxle rear support insulator bracket.
- To install, tighten to 48 Nm (35 lb-ft).

7. To install, reverse the removal procedure.