Transaxle Support Insulator - LH

Transaxle Support Insulator - LH













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the Air Cleaner (ACL). For additional information, refer to Intake Air Distribution and Filtering - 2.5L Air Cleaner.

3. Using the Engine Support Bar and Adapters, support the engine.





4. Remove the 4 LH transaxle support insulator bolts.
- To install, tighten to 48 Nm (35 lb-ft).

5. Remove the through bolt and the LH transaxle support insulator.
- To install, tighten to 103 Nm (76 lb-ft).

6. Remove the 3 nuts and the LH transaxle support insulator bracket.
- To install, tighten to 40 Nm (30 lb-ft).

7. To install, reverse the removal procedure.