Removal and Replacement

Engine Support Insulators









Removal and Installation

1. Remove the engine support insulator bracket bolt.
- To install, tighten to 115 Nm (85 lb-ft).

2. NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

Position a floor jack with a block of wood under the front of the oil pan.

- Using the floor jack, lift the engine 12 mm (0.47 in).





3. Remove the nut and ground wire eyelet from the engine support insulator bracket stud.
- To install, tighten to 25 Nm (18 lb-ft).

4. Remove the 3 nuts and the engine support insulator bracket.
- To install, tighten to 55 Nm (41 lb-ft).

5. Remove the 3 bolts and the engine support insulator.
- To install, tighten to 48 Nm (35 lb-ft).

6. To install, reverse the removal procedure.