Radiator Grille Support

Radiator Grille Support









Removal and Installation

1. Remove the front bumper cover. For additional information, refer to Bumpers Service and Repair.

2. Remove the headlamp bolts. For additional information, refer to Exterior Lighting Service and Repair.

3. Disconnect the battery. For additional information, refer to Battery, Mounting and Cables Battery Disconnect.

4. Remove the 4 electrical junction box bolts.
- To install, tighten to 35 Nm (26 lb-ft).





5. Disconnect the ambient air temperature sensor retaining clip and position the sensor and harness aside.





6. Disconnect the horn assembly electrical connector and remove the horn assemble bracket bolt.
- To install, tighten to 35 Nm (26 lb-ft).





7. Disconnect the hood latch cable retainers, remove the hood latch assembly bolts and position the latch assembly and cable aside.
- To install, tighten to 35 Nm (26 lb-ft).





8. Remove the LH and RH coolant module bolts.
- To install, tighten to 15 Nm (133 lb-in).





9. Remove the 6 radiator grille support bolts (3 each side).
- To install, tighten to 35 Nm (26 lb-ft).





10. Remove the radiator grille support.

11. NOTICE: Inspect and transfer all of the radiator grille support isolators. Replace as necessary.

NOTE: Transfer all necessary components.

To install, reverse the removal procedure.