Seat Backrest Thermo-Electric Device

Seat Backrest Thermo-Electric Device

Removal and Installation

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. With the backrest fully forward, release the seat backrest cover lower rear J-clip and unzip the 2 side zippers.





2. Remove the climate controlled seat Thermo-Electric Device (TED).
- Disconnect the TED electrical connector.

- Remove the scrivet.

- Detach the 2 retainer clips from the backrest frame support wires.

3. To install, reverse the removal procedure.